DynaMix Power

Kleemann Crusher Wear Parts: MR and MC Series

Blow bars, impact plates, jaw plates and side liners for Kleemann MR110, MR122, MR130, MR150, MC100, MC110 and MC120.

Kleemann splits into MR impactors and MC jaw machines, seven models between them. Both are mobile, and on a mobile machine the constraint that decides your cost is not liner life on its own. It is how long the machine stands still while the liner is changed.

That changes what you should buy, not just what you should pay.

On a mobile impactor the gap matters as much as the bar

A blow bar that wears evenly and slowly on a plant with a well-set gap can be destroyed in days on the same machine with the gap too wide, because oversize lumps hammer the bars instead of being thrown against the plates. When someone reports poor bar life on an MR machine we ask for the gap setting and the feed curve before we discuss alloy. The alloy is the last variable, not the first.

Change time is part of the part

A bar that lasts ten percent longer but takes an extra shift to fit is a worse bar on a contract plant. This is why we ask how the machine is maintained, on site or in a workshop, and whether the rotor is being rebalanced at the same time. Weight consistency between bars matters more on a high-speed rotor than on a slow one, and we will say so when a cheaper set is the wrong call for that reason.

MR and MC codes are not interchangeable

MR is the impactor line and MC the jaw line, and the wear parts do not cross between them. It sounds obvious until an enquiry arrives with a list copied across from a different machine type. We check each line against the machine plate rather than the list.

Models covered

Model	Parts	Chamber options	Material
MR110	Blow Bar, Impact Plate, Side Liner	—	high chrome Cr26, Mn13Cr2
MR122	Blow Bar, Impact Plate, Side Liner	—	high chrome Cr26, Mn13Cr2
MR130	Blow Bar, Impact Plate, Side Liner	—	high chrome Cr26, Mn13Cr2
MR150	Blow Bar, Impact Plate, Side Liner	—	high chrome Cr26, Mn13Cr2
MC100	Fixed Jaw Plate, Movable Jaw Plate	—	Mn18Cr2
MC110	Fixed Jaw Plate, Movable Jaw Plate	—	Mn18Cr2
MC120	Fixed Jaw Plate, Movable Jaw Plate	—	Mn18Cr2

Lead time: 15 to 30 days from drawing or sample

Common questions

Which Kleemann models are covered?

MR110, MR122, MR130, MR150, MC100, MC110 and MC120, with parts listed per model above.

Do you supply ceramic insert blow bars?

We can quote them. They pay back on abrasive feed with a controlled top size and tend to fail at the insert on feed with oversize. We will tell you when the arithmetic does not work for your application.

Can you supply a set with matched weights?

Yes, and on a high-speed rotor you should ask for it. Tell us the rotor speed and whether the set is being fitted with a rebalance and we will quote accordingly.

Fitment and trademark notice

Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.

METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.

Other languages

Tel / WhatsApp: +86 18616330128 | E-mail: ensaichen@dynamixpower.com