DynaMix Power
Home › Spare Parts › metso › gp-series
Mantle, bowl liner and concave castings for Metso GP100, GP200, GP220, GP300, GP330, GP500, GP550 and GP7, made to drawing or sample.
The GP range runs GP100, GP200, GP220, GP300, GP330, GP500, GP550 and GP7. We cast mantle, bowl liner and concave for the whole set, some from patterns in our shop and the rest to drawing.
This is the page where we get the most wrong-part enquiries, and the reason is simple. GP and HP parts look related in a parts book and are not. A liner that is dimensionally close but cut for an HP chamber will go on the shaft and will not crush properly, and by the time that shows the customer has lost a set of liners and a shift.
The two ranges share a manufacturer and a general cone layout, not their castings. Model numbers sit in the same numeric neighbourhood, which is how a GP300 liner gets ordered for an HP300 machine. We check the machine plate against the drawing every time, and when the two disagree we ask before cutting anything. On this page the GP models are listed with their own parts, not pooled with HP.
GP7 sits at the top of the range and the castings are correspondingly heavy. Pattern availability, crane capacity at the loading and unloading ends, and the shipping window all need settling before a date is given. For GP7 we ask for the drawing early and confirm the handling arrangement in writing rather than quoting from an assumed weight.
Three things: the machine model as stamped on the plate, the cavity code cast on the liner, and the drawing or the worn part itself. A part number alone identifies a part in a catalogue, not the geometry in your machine. Where an enquiry arrives with only a number, we quote conditionally and confirm before the pour. Nothing is cut on an assumption.
| Model | Parts | Chamber options | Material |
|---|---|---|---|
| GP100 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
| GP200 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
| GP220 | Mantle | — | Mn18Cr2 |
| GP300 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
| GP330 | Bowl Liner, Mantle, Concave | — | Mn18Cr2 |
| GP500 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
| GP550 | Bowl Liner | — | Mn18Cr2 |
| GP7 | Bowl Liner | — | Mn18Cr2 |
Lead time: 15 to 30 days from drawing or sample
GP100, GP200, GP220, GP300, GP330, GP500, GP550 and GP7, each with the parts cast for it in the table above.
No. The two are separate casting families. If a parts book shows them adjacent, that is a numbering coincidence, not an interchange. Send the machine plate and we will confirm which family you need.
Not for the whole range. Some models run from patterns we hold and the rest are made to drawing or sample. The table states which applies to each model, so the delivery date is not built on an assumption.
Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.
METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.
Tel / WhatsApp: +86 18616330128 | E-mail: ensaichen@dynamixpower.com