DynaMix Power

Home › Spare Parts › metso › hp-series

Metso HP series cone crusher wear parts

Mantle, bowl liner and concave castings for Metso HP100, HP200, HP300, HP400, HP500, HP700, HP800 and HP4, six chamber options, made to drawing or sample.

The HP line is the high-energy cone range and its wear parts are the castings we pour most of. This page covers HP100 through HP800 including HP4, with mantle, bowl liner and concave listed per model in the table below.

The quoting error we see most on this range is treating the model number as the whole specification. An HP300 bowl liner is not one part. The chamber sets the profile, and the profile decides whether the liner wears evenly or steps out at the lower third.

Six cavities, and where each one belongs

The HP cavities run EC, C, MC, M, MF, F. Extra coarse and coarse belong where the feed has come off a jaw and still carries large lumps. MF and F belong in tertiary work, where the reduction is high and the feed is already controlled. Putting a fine chamber in to chase a smaller product without changing the feed gradation raises the circulating load and shortens liner life. It looks like a material problem for a month, then it becomes an obvious chamber problem.

How far to run a liner before changing it

We get asked for a replacement while a bowl liner still has a third of its thickness left. The reasoning is usually that a failiure mid-shift costs more than the casting. That is sometimes right. On an HP300 running 20 hours a day the arithmetic is worth doing properly: measure the remaining thickness at four points round the circumference, not just the thinnest one, and compare the cost per hour of the last third against the cost of an unplanned stop. Where the last third wears at twice the rate of the first, changing early is the cheaper decision. We will tell you when it is not.

Reading the casting before you call us

The cavity code is normally cast or stamped on the back of the bowl liner, and the mantle carries its own marking. Photograph both plus the worn face, and send the machine serial with the enquiry. That turns a three-email exchange about which chamber you have into a single reply with a price on it.

Models covered

Lead time: 15 to 30 days from drawing or sample

Common questions

Which HP models do you cover?

HP100, HP200, HP300, HP4, HP400, HP500, HP700 and HP800. Each appears in the table above with the parts cast for it and the supply basis.

Can you supply a bowl liner for a cavity not listed here?

Yes, from a drawing. The codes on this page are the ones published for the range. If your machine runs a cavity outside that set, the drawing governs and we quote from it.

Will you quote from a part number on its own?

We can start from one. We confirm it against a drawing or a sample before we commit to a delivery date. A cross-referenced number identifies the part. It does not give us the cast geometry.

Fitment and trademark notice

Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.

METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.

Other languages

• RU
• VI
• ES
• AR
• FR

Tel / WhatsApp: +86 18616330128  |  E-mail: ensaichen@dynamixpower.com