DynaMix Power
Home › Spare Parts › metso › mp-series
Mantle, bowl liner and concave castings for Metso MP800 and MP1000 high-capacity cone crushers, made to drawing or sample.
MP800 and MP1000 sit at the top of the cone frames we cover, and the two machines behave differently enough from the HP line that quoting them from HP experience is a mistake. High tonnage, high reduction, and liners that are replaced on a planned stop rather than a breakdown.
On this page we list the parts we cast for each frame. What we will not do is guess a weight or a profile from the model number.
A frame running at high reduction has less room to absorb a chamber that is one step off. Where an HP machine will show a step in the bowl liner and keep working, an MP at the same error loads the mantle and the bowl unevenly and brings the liner to the end of its life early. We ask for the cavity code and the target product curve before recommending a profile, and on these frames the answer is often that the plant should change the chamber rather than the alloy.
MP800 and MP1000 parts are planned, not stocked. Pattern availability, crane capacity at both ends and the shipping window decide the date before the foundry schedule does. We ask for the drawing early and confirm handling in writing. A date offered before that is a guess and we would rather not give it.
These machines are usually the bottleneck of the plant, so the liner change is scheduled. That means the ordering cycle should be driven by hours run rather than by failure. If the plant records hours against liner thickness on the previous set, the next order becomes a date. If it does not, every order is placed against a memory, and the plant either carries excess stock or stops.
| Model | Parts | Chamber options | Material |
|---|---|---|---|
| MP1000 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
| MP800 | Mantle, Concave, Bowl Liner | — | Mn18Cr2 |
Lead time: 15 to 30 days from drawing or sample
MP800 and MP1000, with the parts cast for each listed in the table above.
Ask per model. Some are available from patterns we hold, others are made to drawing. The table states the basis for each, so nothing rests on an assumption about stock.
Yes, provided the worn part still carries its geometry and the markings. A heavily worn liner can locate the profile but not the original thickness, so we confirm the critical dimensions back to you before pouring.
Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.
METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.
Tel / WhatsApp: +86 18616330128 | E-mail: ensaichen@dynamixpower.com