DynaMix Power

Home › Spare Parts › sandvik › cs-series

Sandvik CS series cone crusher wear parts

Mantle, concave and bowl liner castings for Sandvik CS420, CS430 and CS440 cone crushers, seven chambers, variants A, B, HC and FF.

CS420, CS430 and CS440. The frame is smaller than the CH machines of the same number, the chamber and variant logic is the same, and the handling question is the one customers ask about least and get caught by most.

A CS440 mantle in variant B is a casting of just over a tonne. That changes how it is changed, not just how it is ordered.

Smaller frame, not a different casting method

The CS range uses the same chamber letters and mantle variants as the CH range. What differs is the frame, and therefore the tonnage the plant can push through it. A quotation that treats the CS as a small CH and prices the liner accordingly without checking the drawing is how a plant ends up with a casting that does not seat. We confirm the frame from the machine plate, every time.

Weight decides the change, not just the order

Our catalogue figure for a CS440 mantle in variant B is 1147 kg, and for a lower concave in variant C, 878 kg. Treat those as catalogue numbers until they are confirmed against the drawing for your machine, because they move with the chamber. The practical point is that a liner in this class needs lifting equipment and a planned stop, and a plant that orders without checking what it has on site will find out on the day.

Send the marking even when you know the model

The chamber letter and the variant are cast or stamped on the part, not on the machine. A customer who knows they run a CS440 still may not know whether the last liner was B or HC. A photograph of the marking settles it in one exchange. Without it we quote the most common variant and flag the assumption in writing, so nobody is surprised at delivery.

Models covered

Lead time: 15 to 30 days from drawing or sample

Common questions

Which CS models are covered?

CS420, CS430 and CS440, with parts listed per model in the table above.

Are CS and CH parts interchangeable?

No. The chamber logic is shared but the frames differ, so the castings differ. Send the machine plate and we will confirm which range you are on.

Can you confirm the weight before we order?

Yes, once we have the drawing or the casting marking. Catalogue weights shift with the chamber and variant, so we confirm rather than quote the book figure as fact.

Fitment and trademark notice

Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.

METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.

Other languages

• RU
• VI
• ES
• AR
• FR

Tel / WhatsApp: +86 18616330128  |  E-mail: ensaichen@dynamixpower.com