DynaMix Power

Home › Spare Parts › sandvik › h-series

Sandvik H series cone crusher wear parts

Mantle, concave and bowl liner castings for Sandvik H2800, H3800, H4800, H6800, H7800 and H8800 cone crushers, quoted from the H number.

H2800, H3800, H4800, H6800, H7800, H8800. The H numbers are the earlier designation for machines now sold under CH names, and they remain a valid way to order parts. Plenty of plants still run a parts book printed before the renaming, and there is no reason that should cost them a liner.

The page exists because we keep meeting buyers who have been told their H number is obsolete. It is not. It is the same casting under an older label.

The H number is still a valid order reference

We match the H designation to the casting before quoting, the same way we match a CH number. If your book says H4800 and the supplier only lists CH440, that is a catalogue problem rather than a machine problem. Send the H number and the machine serial and the enquiry is workable.

The small frames are still out there

H2800 and H3800 are the smaller frames of the range and they turn up in plants that have no intention of replacing them. Parts for these run from patterns we hold or from a drawing, and the lead time reflects which. What we do not do is decline the enquiry because the model is old.

What to send with an H number

The H number, the casting marking where you have it, and a photograph of the worn face. The marking matters more on this range than on most, because H numbers were reused across cavity variants in some parts books. Where the marking is missing and the drawing is not available, we say so and quote conditionally rather than cutting on a guess.

Models covered

Lead time: 15 to 30 days from drawing or sample

Common questions

Is my H number obsolete?

No. H2800 through H8800 correspond to the machines now sold as CH models. We quote from the H number and confirm against the drawing.

Which H models are covered?

H2800, H3800, H4800, H6800, H7800 and H8800, each listed with its parts in the table above.

What if my parts book gives an H number we cannot match?

Send the machine serial and a photograph of the casting. If we cannot establish the geometry from what you send, we will say so instead of quoting something that might not fit.

Fitment and trademark notice

Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.

METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.

Other languages

• RU
• VI
• ES
• AR
• FR

Tel / WhatsApp: +86 18616330128  |  E-mail: ensaichen@dynamixpower.com