DynaMix Power

Telsmith Cone Crusher Wear Parts

Mantle, bowl liner and concave castings for Telsmith 25, 45, 52, 57 and 66 cone crushers, made to drawing or sample.

Five sizes: 25, 45, 52, 57 and 66. These frames have been in service a long time, and a good number of them are still the primary cone in plants that have no plan to replace them.

Parts for this range are almost always made to drawing or to a sample, and the serial number matters more here than on a modern machine.

The number is a size class, not a specification

The number identifies the cone size class. It does not tell you which cavity or which revision of the bowl you have. Two machines with the same number built years apart can take different liners. We ask for the serial and the old liner, and where the liner is gone we ask for a photograph of the bowl.

Small orders are normal on this range

A lot of these machines run in small quarries or as a secondary in a fixed plant that was built decades ago. That often means one liner at a time rather than a set. We quote single pieces, and we will say when a pattern does not exist yet and a first article has to be made before the price means anything.

Where the extra life usually comes from

On an older cone the gain rarely comes from a harder alloy. It comes from correcting a chamber that was chosen for a different feed years ago and never revisited. If a plant reports that liners wear out faster than they used to, the useful question is what changed in the feed or the setting, not which grade to try next.

Models covered

Model	Parts	Chamber options	Material
25	Mantle, Concave, Bowl Liner	—	Mn18Cr2
45	Mantle, Concave, Bowl Liner	—	Mn18Cr2
52	Mantle, Concave, Bowl Liner	—	Mn18Cr2
57	Mantle, Concave, Bowl Liner	—	Mn18Cr2
66	Mantle, Concave, Bowl Liner	—	Mn18Cr2

Lead time: 15 to 30 days from drawing or sample

Common questions

Which sizes are covered?

25, 45, 52, 57 and 66, with mantle, bowl liner and concave listed in the table above.

Do you hold patterns for Telsmith frames?

Mostly not. The table states the supply basis per model. Where a pattern has to be made, we say so and quote the first-article cost seperately rather than hiding it in the unit price.

Can you work from the serial number alone?

We can start there, but we confirm against a drawing or a photograph of the bowl. A serial tells us which machine; it does not give us the cast geometry.

Fitment and trademark notice

Brand names and model designations on this page describe which machines the parts fit. Shanghai Dynamix Power is an independent manufacturer of aftermarket replacement wear parts and is not affiliated with, authorised by, sponsored by or endorsed by any original equipment manufacturer. Original part numbers, where shown, are cross-references for identification only.

METSO™, SANDVIK®, SYMONS®, TEREX®, KLEEMANN®, TELSMITH® and HAZEMAG® are trademarks or registered trademarks of their respective owners.

Other languages

Tel / WhatsApp: +86 18616330128 | E-mail: ensaichen@dynamixpower.com